Pelgrim GVW580ONY Notice D'utilisation page 30

30
Malfunction
The appliance • The light of the pro-
does not drain gramme in progress
the water. flashes.
• The end-of-programme
indicator light flashes 2
times.
The anti-flood • The light of the pro-
device operates. gramme in progress
flashes.
• The end-of-programme
indicator light flashes 3
times.
The programme
does not start.
After the check, switch on the appliance.
The programme continues from the point of
interruption.
If the malfunction shows again, contact the
service centre.
For other fault codes, not showed in the
chart, contact the service centre.
The necessary data for the service centre is
on the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Fault code
The filter in the water in-
let hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is not
correct.
The water drain hose is
damaged.
The appliance door is
open.
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
The delay start is set.
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
Possible cause
We recommend that you write the data
here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Possible solution
Clean the filter.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter inlet hose has no
damages.
Clean the sink spigot.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter drain hose has no
damages.
Close the water tap and
contact the service cen-
tre.
Close the door correct-
ly.
Put in the mains plug.
Replace the fuse.
If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
....................
....................
....................