Publicité
Les langues disponibles
Les langues disponibles
Description and Installation
1. Convector
2. Towel rail
3. ON/OFF switch with
control light
4. Control panel with
5. Temperature display
6. + Button: 'temperature higher'
7. - Button: 'temperature lower'
8. Timer setting button
Remove all packaging material and keep out of reach of children. After removing packaging,
check the appliance for damage or other signs that could indicate a fault/defect/malfunction. In
case of doubt, do not use the appliance, but contact your vendor for inspection or replacement.
Do not use the heater before it has been installed in accordance with the following
Slide the 4 clips in front of the towel rail over both sides of the convector, 2 on the left and 2
on the right; ensure they are horizontal. Slide the towel rails over the clips and secure onto
the clips with the 4x2 nuts and bolts. The height of the rails can be adjusted later by
carefully sliding.
Choose a solid, flat and completely vertical wall made of non-flammable and non-melting
material on which to mount the heater (i.e. no wood, synthetic materials, etc!)
Decide where you want to mount the heater. Make sure that the heater has sufficient space
around it at all times and that no inflammable materials are located nearby (see also safety
instructions). Do not place the heater behind a door! The heater's underside needs to be at
least 5 cm above the floor, the sides at least 20 cm from the side walls and the top at least
50 cm from the ceiling, ceiling beams, etcetera.
Place the hanging support against the wall, short side with two brackets at the top, brackets
facing forwards. Now mark the location of the 5 screws. Make sure that the top two are
exactly horizontal!
Drill the 5 holes and insert a plug into each.
Screw the support securely to the wall
Slide both the channels on the convector (at the top on the back) over the brackets and
check to ensure that the heater is horizontal and securely attached.
Secure convector and support using the nut underneath by screwing the support to the
convector.
Your heater is now ready for use.
Set-up and Operation
Make sure the heater is turned off (On/Off switch to O). Now plug into an earthed, correctly
functioning 220-240V / 50Hz socket. Only connect the heater to an earthed socket!
LCD-screen
instructions!
19
Publicité
