Hendi 970355 Mode D'emploi page 12

DEVICE OPERATION AND SETTING
Select the pumping and welding parameters* depending on the bag foil type and thickness.
*Note: pumping and welding times are completely dependent on type/size/structure of the food
and the bags you use. The settings provided in the "Use" paragraph are just an indication.
Determine by trial and error which pumping and welding times are suitable for the product/bag
combination you are using at any given time.
While the device is in operation, a single press of the "STOP" key (5) will end the current phase
and skip to the next (vacuuming => sealing; sealing => stopping etc.); keeping the "STOP" key
pressed or pressing it twice will halt all operation and let air flow into the chamber.
Once the parameters of operation are set, these will be used by default every time the lid is kept
closed.
LEDs in the relevant buttons (4, 6) indicate the current stage of operation (vacuuming, sealing).
For setting and memorizing of the following parameters and range thereof:
- pumping time
- welding time
Note:
1. The bag must be straightened on the strip so that no creases or folds occur.
2. The food you want to vacuum should not exceed 2/3 of the contents of the bag.
3. Put the bag on the welding strip with an overlap of approximately 2 cm.
4. Note: soft bread and pastries will be flattened and therefore are not suitable to use.
5. Use only products that are not sensitive to compress like meat, cheese etc.
6. As soon as the cover has been closed, the process will automatically start.
7. The packing process operations (i.e. pumping - welding) are indicated by front panel LED's.
8. The appliance is provided with spacers (shelves) to put in the chamber. These spacers can
be used to lift the food somewhat so that proper bag positioning will be accomplished.
Cleaning and maintenance

Always remove the plug from the socket before cleaning the appliance.

Beware: Never immerse the appliance in water or any other liquid!

Clean the outside of the appliance with a damp cloth (water with mild detergent).

Never use aggressive cleaning agents or abrasives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp cloth and detergent if necessary. Do not use
abrasive materials.

Clean the ventilation slots (if applicable) with the vacuum cleaner.
Errors
 If you hear any unusual noise from the pump. Hold "Stop", remove the plug from the socket
and contact your supplier.
 If there is no oil visible through the sight glass at the back side of the appliance. Do not use the
appliance and contact your supplier.
In case of any doubt, always contact your supplier!
1  99 sec.
1  7.0 sec.