Control Panel Layout - Hendi 970355 Mode D'emploi

CONTROL PANEL LAYOUT*

* The color of the panel can differ
 Vacuum gauge
1
 Vacuum pump operation time increase pushbutton
2
 Vacuum pump operation time decrease pushbutton
3
 Vacuum pump operation time indicator (LED)
4
 Stop pushbutton
5
 Welding time indicator (LED)
6
 Welding time increase pushbutton
7
 Welding time decrease pushbutton
8
 ON-OFF switch
9
 Vacuum pump operation time display
10
 Welding time display
11
Use
1. Open the lid of the appliance.
2. Plug the plug into an earthed socket and push the switch to "On".
3. Set the vacuum time to 50 seconds.
4. Set the melting time to 5,5 seconds.
5. Fold the top of the plastic bag back inside out about 5 cm. This should keep the top of the bag
clean, so the melting strip can perform proper sealing.
6. Fill the vacuum bag up to 2/3 max. with the product you want to vacuum-seal.
7. Fold the top of the plastic bag back to its original position.
8. Position the bag in the middle of the chamber and let the end of the bag protrude about 2 cm
over the seal bar.
9. Close the lid and close the bracket. Make sure the lid is closed and the vacuum can be
created.
10. After the set vacuum time that has passed, the appliance will melt the bag according to the
instructions.
11. After melting the bag, the appliance will release the vacuum of the chamber. On the appliance
will be shown "Ai
12. Finally a "d" appears on the left display. This means that in this stage the appliance is cooling
down. You will see on the right display the alarm counting down from 2.5 seconds to 0.
13. Open the lid by pulling the bracket downwards and at the same time protecting the lid with your
hands.
14. The vacuum-sealed product can now be taken out of the appliance.
r".