Startup Procedure; Shutdown Procedure - Mettler Toledo InTrac 787 Instructions D'utilisation

12
4.3

Startup procedure

Before startup, all fitting and installation work must have been
completed and the immersion tube must be secured to the ball
valve with the safety chain!
3
4
1
4.4

Shutdown procedure

3
1
InTrac 787-01-CH
52 402 481
5
2. Open the ball valve.
3. Carefully push the immersion tube by
2
hand into the process.
4. Secure immersion tube in this position by
tightening the locking nut.
1
5. Shorten the safety chain to the shortest
possible length.
1. Loosen the locking nut.
2. Hold immersion tube, then disconnect
the safety chain.
2
3. Move immersion tube by hand to "Main-
tenance" position.
4. Close the ball valve.
4
© 05/10 Mettler-Toledo GmbH, CH - 8606 Greifensee
1. Warning! Close the valves on
both connections of the flush-
ing chamber.
process media can escape
while the ball valve is opened!
5. Caution! Make sure that the
process vessel or line is in
a non-hazardous condition
(depressurized, empty, rinsed,
purged, etc.) when the housing
has to be removed.
Printed in Switzerland
InTrac ® 787
Otherwise