Cleaning And Maintenance - Signature SHD90FLIGNE Instructions D'utilisation

CLEANING AND MAINTENANCE

The cleaning of the carbon grease filer mesh.
The filter mesh is made of high desity aluminum. Please do not use corrosive detergent
for cleaning. The proper function of the unit is conditioned by the regularity of the
maintenance. Please strictly follow the guidelines below:
Method 1: Put the mesh into 40-50℃ warm, soapy solution and soak about 2-3 minutes.
Wear a glove and clean with a soft brush. Please do no apply too much pressure, as
the mesh is delicate and can be damaged easily
Method 2: The filter can be cleaned in dishwasher, set the temperature at around
60℃.
The installing drawing of filterA1
10
Notice of cleaning cooker hood
To protect the main body from corrosive of the long time accumulation of dirt, the
cooker hood should be cleaned with hot water with non-corrosive detergent every
two months.
Please do not use abrasive detergent for it will damage the body.
Keep the motor and other spare parts free from water as this will cause damage to the
appliance.
Before cleaning the appliance, please remember to cut off power.
If the plug or cord is damaged, please call after-sale service center.
There is a fire risk if cleaning if not carried out in accordance with the instruction
regulations concerning the discharge of air have to be fulfilled.
In case of damaged connecting wire, refer service to the manufacturer, after-sale
service personnel or other qualified technicians.
When the cooker hood is shared with other gas or other fuel burning device, the room
must be well-ventilated.
The unit according to the instructions to avoid any fire hazard.
Do not make fire under the cooker hood.
Do not vent exhaust in to chimneys where other gas or other fuel burning device may
mix together.
The gas emission shall conform to relevant stipulations.
-20-