Cleaning And Maintenance - Signature SHD6X Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. CLEANING AND MAINTENANCE

Changing and cleaning the anti-grease filters
Removing the filters as the instruction in Pic. 8
You can clean the filter as below measure:
1. Soak them for about 3 minute in hot water (40-50 degrees) with
a grease-loosening detergent then brush it gently with a soft
brush. Please do not apply too much pressure, avoid damaging it.
2. It can be put into a dishwasher with detergent, set the
temperature at around 60 degrees.
Please do not use abrasive detergent for it will damage the hood.
Make sure that the hood is shut off before cleaning.
Installing the charcoal filter (see Pic. 9)
1. Remove the filters see Pic.8
2. The charcoal filters (Pic.9) are located at both end of the motor.
Turn the charcoal filters until they are unscrewed.
3. Apply reverse procedure to uninstall the charcoal filter.
Warning: the charcoal filer cannot be washed or recycled.
It should be replaced after approximately 120 hours of use.
Changing the light
1. Before changing the lights, make
surethat the appliance is plugged
off.
2. Take the bracket and glass off and
then take he broken light bulb off,
See Pic 10
3. Fix the new light bulb,glass and
bracket on.
- 14 -
Inside page

Publicité

Chapitres

Table des Matières
loading

Table des Matières