Trouble Shooting - Signature SHD90FLIGNE Instructions D'utilisation

TROUBLE SHOOTING

Fault Cause
Light on, The blades are blocked
but motor
The capacitor is damaged
does not
The motor is damaged
work
The internal wire of motor is cut off/
disconnected. And unpleasant smell
may be produced.
Both light Apart from the above mentioned, check the following:
and motor
Light damaged
do not
Power cord loose
work
Oil Outlet and the air ventilation
leakage entrance are not tightly sealed
Leakage from the connection of
U-shaped section and cover
Vibration The blade, if damaged, can causes
vibrating
The motor is not tightly fastened
The cooker hood is not tightly fixed
Insufficient The distance between the cooker
suction hood and the cooker top is too large
Too much ventilation from open
doors or windows
The The fixing screws are not tight enough
machine
inclines
The hanging screws are not tight
enough.
Solution
Replace capacitor
Replace motor
Replace motor
Replace lights
Connect the wires as per the
electric diagram
Take down the outlet and seal
with glue
Take U-shaped section down and
seal with soap or paint
Replace the blade
Fasten the motor tightly
Fixed the cooker hood tightly
Readjust the distance
Choose a new place to install the
appliance or close some
doors/windows
Tighten the fixing screw and
make it horizontal
Tighten the hanging screw and
make it horizontal
-21-