Cleaning And Maintenance - Signature SHD60FLIGNE/3 Manuel D'utilisation

5. CLEANING AND MAINTENANCE

Changing and cleaning the anti-grease filters
● Removing the filters as the instruction in Pic. 10.
● You can clean the filter as below measure:
Soak them for about 3 minute in hot water (40-50 degrees) with a
grease-loosening detergent then brush it gently with a soft brush. Please
do not apply too much pressure, avoid damaging it.
● Please do not use abrasive detergent for it will damage the hood.
● Make sure that the hood is shut off before cleaning.
Change the charcoal filter (see Pic. 11).
1. Remove the filters see Pic.10.
2. The charcoal filters (Pic.11) are located at both end of the motor.
Turn the charcoal filters until they are unscrewed.
3. Apply reverse procedure to uninstall the charcoal filter.
Warning: the charcoal filer cannot be washed or recycled.
It should be replaced after approximately 120 hours of use.
Pic.10 Pic.11
- 30 -
Open
Close