Signature SHD90FLIGNE Instructions D'utilisation page 20

Inside chimney bracket
Notice of Installation
Any installation work must be carried out by a qualified electrician or
●
competent person.
Do not connect the ducting system of the hood to any existing ventilation
●
system which is being used for any other appliance. Such as warmer tube,
gas tube, and hot wind tube.
The angle of the bend of the ventilation pipe should not be less than 120° ;
●
you must direct the pipe horizontally or alternatively, the pipe should go up
from the initial point and should be led to an outer wall.
After the installation, make sure that the cooker hood is level to avoid grease
●
collection at on end. See Fig.8.
Inside chimney
Outside chimney hook
Outside chimney
-18-