Restriction Of Use; Low-Voltage Protection - WOLFF 038587 Mode D'emploi

Use this machine only
as instructed in this
with the machine in perfect working order.
Wolff cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
TURBO-STRIPPER 230V, Artikel Nr. 038587 ab Masch. Nr. 0001/06
3.1 Introduction
This operating manual should be used to get the most benefit
from your Turbo-Stripper.
Following these instructions will both extend the life of your
machine and reduce repair costs. Please ensure any user of the
machine is fully familiar with the instructions for use before
allowing work to start.
3.2 Danger while working with the machine
The Turbo-Stripper is designed to the highest technical
standards. Incorrect use can be dangerous!
operating manual
Disturbances that could impair safety, have to be eliminated at
once.

3.3 Restriction of use

The Turbo-Stripper is exclusively for removing bonded floor
coverings in dry environments.
It should not be used for any other purpose. Wolff cannot be
held responsible for any damage or loss caused by incorrect
use.
3.4 Genuine Spare Parts
Spare parts and accessories are manufactured uniquely for the
Turbo- Stripper. It must be emphasized that parts obtained from
unauthorized sources must not be used.
Wolff cannot be held responsible for the performance of or any
damage arising from the use of machines in which genuine
spare parts have not been used.
This is particularly important with replacement blades.

3.5 Low-voltage protection

The Turbo-Stripper is equipped with a low-voltage protection
switch. The power supply breaks if current fluctuation or mains
power failures occur, thus preventing serious perilous accidents.
Due to the restart protection, the machine will not restart after a
power failure, even if the operation switch has not been
switched off.
For using the protective cut-out switch see also item 5.0
Application
10