Trouble Shooting - WOLFF 038587 Mode D'emploi

Emergency running
The Turbo-Stripper can be operated also with broken or damaged
hand clutch as follows:
disconnect power supply
remove emergency-run-plate (1) (mounted on top of the
plug of the hand clutch (2) )
insert emergency-run-plate instead of the plug
screw-in thumb-screw (3) until the driving wheels are
blocked
fix emergency-run-plate with thumb-screw (4)
If the emergency-run-plate is mounted, the motor drive is
always switched on. The machine starts running immediately
after switching on.
6.0 Information about certain floor coverings
Needlepunch felt and tufted carpets on jute hessian backings
Cut into strips of approx. 35 cm (14inch) width. If the flooring is
bonded very tight, cut strips smaller. The machine should remo-
ve the flooring without slipping wheels.
Carpets with foam backing
A sharp blade is essential in order to ensure the floor covering is
removed together with the foam backing.
Remove floorings across the width, particularly if you have an
uneven sub-floor.
Tiles
Use blade of the same width as the tiles and use a new blade.
Tiles above size 30 x 30cm (12 x 12inch) have to be cut into half.
If the sub-floor is uneven, use smaller blades.
In all cases, check from time to time to ensure the blade is still
sharp. If it is not or any distortion has occurred, replace it imme-
diately.

7.0 Trouble Shooting

Trouble Eventual cause
Machine does not Power supply
run disconnected
blown fuse
defective cable or plug
Undue force necessary Blade is blunt
or excessive vibration
Excessive vibration Expendable parts are
worn out
TURBO-STRIPPER 230V, Artikel Nr. 038587 ab Masch. Nr. 0001/06
Elimination
Have machine
repaired by a qualified
electrician, respective
change parts
Change blade
Return machine for
service and/or repair
1
4
3
13