SinePower
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
8.3
Mounting the inverter
➤ Hold the inverter against the installation location and mark the fastening
points (fig. 3 A, page 4).
➤ Attach the inverter using your chosen fastening method (fig. 3 B,
page 4).
9
Connecting the inverter
9.1
General instructions
!
WARNING!
The inverter may only be connected by a qualified workshop.
The following information is intended for technicians who are
familiar with the guidelines and safety precautions to be ap-
plied.
Never use the inverter on vehicles where the positive terminal
of the battery is connected to the chassis.
If you do not fit a fuse to the positive cable, the cables can
overload, which might result in a fire.
When installed in vehicles or boats, the inverter must be connected to the
chassis or earth.
When setting up a socket distribution circuit (mains setup), comply with
the applicable regulations.
Only use copper cables.
Keep the cables as short as possible (< 1 m).
EN
Connecting the inverter
43