Mounting The Mains Rectifier; Using The Mains Rectifier - Dometic Waeco CoolPower EPS100 Instructions De Montage Et De Service

CoolPower EPS100
6

Mounting the mains rectifier

If you wish to mount the mains rectifier in a fixed position, please observe the
following mounting instructions:
 Do not mount the device
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
 The place of installation must be well-ventilated. A ventilation system
which is at least equivalent to the air openings in the device must be pre-
sent for installations in closed housings.
 The air intake on the underside or the air outlet on the back of the device
must remain clear.
 The installation surface must be level and sufficiently sturdy.
➤ Secure the mains rectifier with the fastening bracket (fig. 2, page 3).
7

Using the mains rectifier

A
NOTICE!
 Do not reverse the polarity. If the poles are reversed device
may overheat and be damaged.
 Replace defective fuses with new ones of the same rating
(12 A slow-blow).
➤ Fit wire sleeves to the ends of wires which you wish to connect to the
mains rectifier.
I
NOTE
To avoid drops in voltage and therefore performance, keep the
cable route as short as possible and only disconnect it when
necessary.
EN
Mounting the mains rectifier
19