Westfalia 321 556 391 101 Instructions De Montage page 24

Installing the electrical kit
13. Fit together the 2-pin housing of the socket cable set and the 2-pin housing of the 8-core
cable set and let them lock into place.
14. Connect the brown wires with the eyelets to the vehicle's ground point (Fig. 1/4).
15. Lay the rest of the cable set along the vehicle's cable harnesses / ducts on the right side up to
the heel plate between the B- and C-pillar. Cross sides here and lay it to the left and from
there to the area of the network control unit on the left side at the vehicle's front (Fig. 1/2).
16. Push open the red latch on the network control unit. Unplug the black 12-pin plug (port G) and
open the latch. Unlock the following cables and insert them into the black 3-pin socket
housing provided on the cable set:
The orange/brown cable from compartment 7 into compartment 1.
-
The orange/green cable from compartment 8 into compartment 3.
-
17. Insert the individual orange/brown and orange/green cables of the cable set into the now free
compartments 7 and 8 of the 12-pin plug as indicated by the colours.
18. Close the latch. Plug the plug back into the network control unit and push the red latch on the
network control unit shut.
19. > MY2006: Lay the single black/red cable to the brake light switch. Unplug the vehicle's 4-pin
housing and open the secondary latch. Unlatch the red/black cable from compartment 4 and
insert it into the 1-pin socket housing on the cable set. Insert the single black/red cable of the
cable set into the now free compartment 4, close the secondary latch and let the housing lock
back into place on the brake light switch. Fit the now open black 1-pin housings together.
Note
Make sure not to alter the adjustment of the brake light switch when connecting the cable set!
The brake light switch has to be readjusted in accordance with the VW repair guide!
20. MY2007 >: The black housing and the short wire at the black/red wire cut off (no more
necessarily).
Vehicles with BSG Medium or High: Connect this line with enclosed gumption clamping link
professionally with the line on chamber of 2 in the 16-pin plug on location "E" at the electrical
system controller (BSG).
Vehicles with BSG Basis: Lay this line to the relay on card location 1 (REB) in the relay
support over the BSG and connect it with enclosed gumption clamping link professionally with
the line black/red on chamber 2.
21. Push open the purple latch on the fuse carrier (Fig. 1/3).
22. Insert the following cables into the fuse-protected side of the fuse compartment.
The black/violet cable into compartment 2 (
-
alternatively into another free compartment already equipped with terminal 15.
Red/black cable in compartment 40, alternatively into another free compartment already
-
equipped with terminal 30
Red/blue cable in compartment 41, alternatively into another free compartment already
-
equipped with terminal 30
23. If the original fuse positions 39 -41 are to be used and are not equipped with terminal 30 on
the vehicle, the supplied cable adapter has to be installed. Otherwise continue with step 26.
24. Lay the cable end with the cable lug through a suitable opening in the mounting plate bush to
the constant plus distributor of the central electrical system (EM-Box) in the engine
compartment.
24
MJ 2005), compartment 13 (MJ 2006
321 556 391 101 - 009 - 04/08
Installation instructions:
Electrical system for towing hitch
VW Caddy III, Caddy Maxi
),