LaserLiner Quadrum DigiPlus Mode D'emploi page 20

Manual slope function up to 6° – vertical
1.
X
Y
!
When the maximum slope range of 6° has been reached, the laser will stay fixed and blink and
emit a sound. In this case, reduce the slope angle.
Manual slope function > 6°
Steeper slopes can be set using the angle plate, which is
available as an optional extra (product ref. 080.75).
TIP: Allow the device to align itself automatically and set
the angle plate to the zero position. Then switch off the
automatic sensor. See: Manual slope function up to 6°.
Finally, incline the device to the angle you require.
!
When the hand symbol appears on the LC display, the automatic sensor is not activated
and therefore horizontal and vertical levelling is not possible.
Laser modes
Rotary mode
The following speeds can be set using the rotary button:
0, 60, 120, 300, 600 rpm
Spot mode
You access spot mode by pressing the rotary button repeatedly until
the laser stops rotating. The laser can then be positioned exactly at
the measuring point by means of the direction buttons.
Scan mode
The scan button can be used to activate and set a lightintensive
segment in 4 different widths. You position the segment via the
direction buttons.
Hand receiver mode
Working with the laser receiver (available as an optional extra): Set the
rotary laser to maximum speed and switch on the laser receiver. Refer
to the operating instructions for the respective laser receiver about this.
20
GB
2.
auto man
3 sec
3. 4.
man
Y
5.
X
man
3 sec