LaserLiner Quadrum DigiPlus Mode D'emploi page 21

Working with the reference/plumb laser
The unit has two reference lasers. In horizontal operation these lasers
can be used to drop a perpendicular. In vertical operation these reference
lasers are used to align the unit. This is done by adjusting the reference
lasers parallel to the wall. This aligns the vertical laser plane at a right
angle to the wall, see illustration.
Technical data
(Subject to technical alterations. 07.16)
Self-levelling range
Accurancy
Horizontal / vertical levelling
Self-levelling alignment time
Vertical reference beams
Rotation speed
Remote control
Laser wavelengths
Laser wavelength plumb laser
Laser class
Laser output rating
Power supply
Rechargeable battery life
Non-rechargeable battery life
Battery recharging time
Operating temperature
Storage temperature
Protection class
Dimensions (W x H x D) / Weight (incl. batteries)
Remote control
Power supply
Remote control range
Dimensions (W x H x D) /
Weight (incl. batteries)
EU directives and disposal
This device complies with all necessary standards for the free movement
of goods within the EU.
This product is an electric device and must be collected separately for disposal
according to the European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at: www.laserliner.com/info
Quadrum DigiPlus
± 6°
± 0,75 mm / 10 m
Automatic with electronic sensors
and servo motors
Approx. 30 seconds over the entire operating angle
90° to rotation plane
0, 60, 120, 300, 600 RPM
Infrared IR
635 nm
650 nm
2 (EN60825-1:2014)
< 1 mW
High-performance rechargeable
battery / batteries (4 x type C)
approx. 35 h
approx. 50 h
ca. 6 h
-10°C ... + 50°C
-10°C ... + 70°C
IP 66
215 x 205 x 165 mm / 2,6 kg
2 x type AAA
max. 40 m (IR-Control)
63 x 130 x 24 mm /
0,15 kg
21
GB