LaserLiner Quadrum DigiPlus Mode D'emploi page 19

Digital inclination function (dual grade function)
The horizontal plane can be inclined digitally in the x and y-axes. The maximum
inclination of a plane is up to ±10%. In the sum of both axes, the maximum value
is reduced per each axis. On the large LC display, the values are displayed and can
be entered independently.
Setting the axes: Press the auto/slope button (1). The x-axis indicator blinks on the
LC display. The numbers can be set with the Plus and Minus buttons (5/6). Switch to
the y-axis by pressing the X/Y button (2). Then the y value can be set with the Plus
and Minus buttons (5/6). Pressing the X/Y button (2) again confirms the entry. The
device then adjusts to the desired value. Refer to the illustrations below.
X
Y
Important: It is not possible to enter any information while the device is levelling. The LC display shows
the blinking levelling symbol (17). When the levelling symbol stops blinking, levelling is complete and
new numbers can be entered.
!
The automatic sensor is activated whenever the digital slope function is in use.
!
The X/Y axes are marked on the device.
Manual slope function up to 6° – horizontal
Activation of the slope function deactivates the automatic sensor, To return the laser to manual mode,
keep the ON/OFF button pressed until the hand symbol (19) appears on the LC display. Press the X/Y
button to set the horizontal plane. The plus/minus buttons are used to re-adjust the slope by means of
a motor. In the process the X-and Y-axis can be adjust separately. Refer to the illustrations below.
X
Y
1. 2.
auto
1. 2.
auto man
Quadrum DigiPlus
3.
(± 10%)
X
3.
man
3 sec
On 1 plane
On 2 planes
4. 5.
Y
4. 5.
± 6°
X Y
19
GB