Battery Charging - LaserLiner Quadrum DigiPlus Mode D'emploi

Battery charging

– Charge the device's battery completely prior to use.
– Connect the charger to mains power supply and the charging
socket (J) of the battery compartment (L). Please only use the
charger supplied; using a different charger will invalidate the
warranty. The rechargeable battery can also be charged when
it is not inserted in the device.
– When the rechargeable battery is being charged, the LED on
the charger (N) lights up red. When the LED changes to green,
charging is complete. When the unit is not connected to the
charger the power charger's LED lamp will blink.
– Alkaline batteries (4 x type C) can be used as an alternative.
Insert them in the battery compartment (K) as per the
installation symbols.
– Insert battery (L) / battery compartment (K) into slot (G) and
secure it in place with fastening screw (I). The electrical
contacts (H) must be connected.
– With the rechargeable battery inserted, the device is ready
to run even during charging.
– If the battery symbol (14) flashes continuously on the LC display,
the batteries must be replaced or the rechargeable battery must
be charged.
Insert batteries into the remote control
– Observing the correct polarity.
Quadrum DigiPlus
–
C
H
G
+
K
J
L
I
15
GB