Battery Replacement - LaserLiner AQua-Master Mode D'emploi

AQua-Master
Operation of the AQua-Master
Charging the batteries:
• Fully charge the batteries before use.
• When LED (L) located next to vertical vial (B) starts to blink, recharge the
batteries.
• Plug the charger/mains adapter into the power socket and into socket (D).
The control lamp lights up in red during charging. As soon as the light
changes to green, charging is completed. The detachable battery pack can
be recharged either attached to or separate from the rotation laser.

Battery replacement:

If the red LED (L) blinks constantly, the batteries must be replaced or the battery
pack must be recharged. To do this, release the screw on the battery pack/battery
compartment and remove the compartment.
Note: When the LED starts blinking, the rechargeable battery must be
recharged immediately; in battery operation, it is possible to continue working
with the rotation laser for another few hours.
Connection of external mains adapter:
Please use only the mains adapter supplied with the device. Use of a different
adapter will render the warranty void.
Note: Do not expose batteries to excessive heat such as sunshine, fire, etc. Dry
batteries must not be recharged. Used batteries must not be disposed of as
household waste. Please take them to a collection point for used batteries or for
special waste. Ask your local authority for further details. Batteries with the
recycling symbol can also be returned to our dealerships or to our Technical
Service.
Insertion of batteries in the SensoCommander:
• Remove the battery cover (9) and insert the batteries as shown by the
installation symbol, ensuring that the polarity is correct. Then replace the
cover.
• To extend battery life, the receiver switches off automatically after about
5 minutes if not used.
16
Deutsch
ENGLISH
1