sylvac WORK BASIC Mode D'emploi page 8

E
mm
mm
mm
4. Switching off
The dial gauge goes automatically into stand-by if not used for 20 minutes. the value of the origin is retained by the sensor
(SIS mode), and the instrument automatically restarts with any movement of the measurement probe, or RS232
The instrument can be switched off completely for a long period of non-use, but this will necessitate a zero reset on restart
(the origin will be lost): prolonged press (>4 sec) on button.
Units selection (mm or Inch)
↓
Choice of measurement direction (positive or negative
sense)
mm
IN
8
command.