The ignition is
The 12V electrical pow-
switched on but
er socket fitting is dirty.
the massage
The contact is therefore
cushion does
interrupted.
not work.
The fuse of the 12V plug
has blown.
The vehicle fuse has
blown
9. Technichal data
Dimensions:
External material:
Max. temperature:
Power rating:
Power supply:
Protection class:
Fuse in the 12V plug:
This massage cushion has been tested by TÜV Rheinland Group (TÜV Kraftfahrt
GmbH. Institute for Traffic Safety, Type testing vehicles/vehicle parts, Am Grau-
en Stein, 51105 Cologne).
Suitability for side airbags rated and tested in comparison with series produc-
tion. See application range (type list) and technical report no. 83SG0170.
Retrieve under www.walsergroup.com/clix
10. Declaration of Conformity
The EU declaration of conformity can be requested from
the manufacturer.
11. Disposal
11.1 Disposal of packaging
Dispose of the packaging separated by type. Put paper board
and cardboard in paper recycling, and plastic films in material
recycling.
11.2 Disposal of old appliances
(Applicable in the European Union and other European countries with systems
for separate collection of recyclables)
Old appliances must not be put in household waste!
If the massage cushion is longer usable, each consumer is requi-
red by law to dispose of old appliances separately
from household waste, e.g. at a collection site in his commu-
nity/city district. This ensures that old appliances are properly used
and negative effects on the environment are avoided. Therefore, electrical and
electronic equipment is marked with the above symbol.
12. Manufacturer
Walser GmbH
Radetzkystraße 114
6845 Hohenems
Austria
office@walsergroup.com
User manual status 25.06.2020
13. Service & Guarantee
This product has been produced with great care and under continuous quality
control. The product comes with a three year guarantee from date of purchase.
Please keep your receipt safe. The guarantee applies only to material and
manufacturing defects and does not apply to misuse or improper treatment.
Your statutory rights, especially the rights of warranty, are not restricted by this
guarantee.
Extent of validity: Please use the service hotline which has been provided for
you or contact the service centre in the European Economic Area.
GB/IE/NI 8
Clean the 12V vehicle power
socket properly.
Replace the fuse of the 12V plug,
see section "Maintenance".
Replace the vehicle fuse
for the 12V vehicle power
connector. Please refer to the
handbook for your vehicle.
ca. 119 x 48cm
100% Polyester
49° C
max. 12 W
12V
III
(5x20 mm), type F3AL250V
Costs: Repair or replacement free of charge or a refund of the purchase cost.
Shipping costs will not be charged.
Advisory notice: Before returning your product, contact our hotline by tele-
phone, so that we can help you with any operating errors.
Service address:
Walser Industrie- und Handels GmbH
office@walsergroup.com
www.walsergroup.com
Free Service Hotline: 00800 00300030
Return address:
Walser Customer Service Germany
Walser GmbH
Bleicheweg 15, Postfach 3325
DE-88131 Lindau
GERMANY
IAN 346416