Working With The Machine; Warning Signal; Service And Maintenance - Festool ETSC 125 Li Notice D'utilisation Originale

Dust extraction with Festool's mobile dust ex­
tractor
To prevent having to frequently empty the dust
bag when carrying out sanding work for a long
period of time, you can connect Festool's mo­
bile dust extractor (with an extraction hose di­
ameter of 27 mm) to the extractor connection
piece [1-5].
The start-up mode switches the mobile
dust extractor on as soon as you switch
the orbital sander on. The start-up mode
only works in conjunction with the mains
adapter.
If the power tool is used in cordless op­
eration with a mobile dust extractor, the
battery life decreases. Reducing the
suction power minimises this effect.
High suction power can impair control of
the power tool. Reducing the suction
power minimises this effect.
Recommendation: Use an antistatic suction
hose. This helps reduce the electric charge.
7.5 Edge protector [6]
The edge protector [1-8] reduces contact of the
sanding pad circumference with a surface (e.g.
when sanding along a wall or a window), thus
preventing back-kick of the machine, or ma­
chine damage.
Push the edge protector into the groove on
the machine.
Slot the two ends of the edge protector into
place until they click.
Loosen both ends of the edge protector.
Remove the edge protector by pulling it for­
wards.
8

Working with the machine

WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
Observe the following instructions:
– Do not overload the machine by pressing
with excessive force! The best sanding re­
sults are achieved with moderate applica­
tion pressure. The sanding capacity and
quality are mainly dependent on the selec­
tion of the correct abrasive.
– Hold the machine with one hand on the
handle [1-9].
8.1

Warning signal

The machine shuts down and makes a sound:
► Switch off the machine.
Battery pack is empty.
► Change the battery pack.
The machine shuts down and does not make a
sound:
Machine is overheated or has been overloaded.
► Switch off the machine for 30 seconds.
► Reduce the machine load.
If the machine's final speed is then not reached,
allow the machine to cool down.
9

Service and maintenance

WARNING
Risk of injury, electric shock
► When carrying out servicing and mainte­
nance work, always remove the batteries
or the mains adapter from the power tool
first.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of any obstruction.
In the event of a slowdown in performance or
increased vibrations, blow and clean cooling air
openings.
► Keep the contacts on the machine, charger
and battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note en­
closed instructions of the battery pack!
English
17