Working With The Machine; Service And Maintenance - Festool LEX 2 185/7 Guide D'utilisation

Tuned to the surface being processed, the machine
can be equipped with three sanding pads of differ-
ent hardnesses.
Hard: Coarse and fine sanding on surfaces. Sand-
ing edges.
Soft: Universal for coarse and fine sanding, for flat
and convex surfaces.
Extra-soft: Fine sanding of moulded parts, arches,
radii. Do not use on edges.
Please observe all mentioned safety informa-
tions and the following rules when working:
– Always secure the workpiece in such a manner
that it cannot move while being processed.
WARNING
Risk of injury

The machine should always be disconnected
from the compresses air supply before any work
is carried out on the machine.

All maintenance and repair work which requires
the motor casing to be opened may only be car-
ried out by an authorised service centre.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festoolusa.com/service
EKAT
Use only original Festool spare parts!
4
Order No. at:
5
3
2
www.festoolusa.com/service
1
10
Attaching sanding accessories using Stick-
The suitable StickFix sandpaper and StickFix sand-
ing cloth can be attached quickly and simply to the
StickFix sanding pad.

Press the self-adhesive sanding accessory onto
the sanding pad [4-1].

Working with the machine

Service and maintenance

We recommend that the vanes on the motor be re-
placed after approx. 500 operating hours.
The rubber sleeve [5-1] brushes off the sanding
pad and prevents uncontrolled turning of the sand-
ing pad. This must be replaced if the braking effect
decreases.
Fix
For work that generates dust, wear a dust
mask.
Vanes
Sanding pad brake
5.3
5.4
5.2
5.1
5