Publicité
Les langues disponibles
Les langues disponibles
User Manual
Overview
Front Panel
1. LCM
Display's the current Input/Output status and can be used to view the EDID Management Window
2. IR Window / Power / Lock
IR Window – Receives commands from the supplied IR Remote Control
Power – Use to switch the Matrix On (LED illuminates Green) or to Standby (LED illuminates Red)
Lock – Press to Lock all other buttons on the front panel, press again to unlock.
3. Output/Input
Press one of the Output A – D or All buttons and then press Input 1 – 4 to select which Input to display
Press PTP to reset the Input/Output combination to A1, B2, C3 and D4.
4. EDID
Configure which EDID is used for each input port
Rear Ports
1.
PC Control
TCP/IP: Connect the Matrix to an Ethernet network to allow it to be controlled by a PC/Controller on
the network
RS-232: Connect a PC/Controller to the Matrix using a 9 Way RS-232 cable
2.
IR Ports
IR Output: Ports 1 – 4 control the HDMI Equipment on the corresponding HDMI Input port
IR Input: Ports 1 – 4 control the HDMI Display connected to the Receiver using the corresponding
CAT. 6 Output port
IR Ext: Allows the IR port used to control the matrix to be extended
English
Publicité
