EN
Use
CAUTION!
■
Danger of burns! The device becomes very hot during operation. Do not touch it
when it is switched on or immediately after it has been switched off! Only ever touch
the ON/Off switch or use potholders or oven gloves.
■
Only dry corn kernels may be poured into the device. Never pour additives
such as butter, oil, water, sugar, salt or herbs into the device. Only season the
popcorn once it is cooked.
■
Do not pour any old popcorn into the device as it may burn on and produce smoke.
■
Never overfi ll the corn pot! This may result in burning of burst popcorn and smoke
being produced as broken kernels cannot get out of the corn pot.
1. Place the base on a dry, even, and fi rm surface. Make sure you follow the notes on
set-up and connection in the "Safety Instructions" chapter.
3. Remove the lid, which also serves as a measuring cup, and fi ll it up to the top with
popcorn corn. If the cup is heaped, skim off excess kernels with your fi nger. CAU-
TION: Never pour too little or too much corn into the corn pot! If there is too little
corn, only a few corn kernels may break open and too many kernels may stay hard.
Overfi lling the corn pot may result in the popcorn burning.
8. The corn pot heats up and causes the corn kernels to break open. After just a few
minutes, you will hear the typical sound of popcorn popping. The cooked popcorn
then slides into the bowl which has been provided for it. If you can hardly hear the
popping noise, switch off the device (switch position 0) and tilt it towards the bowl in
order to remove all of the popcorn from the device.
04672_DE-EN-FR-NL_A5_V1.indb 18
04672_DE-EN-FR-NL_A5_V1.indb 18
18
2. Make sure that the popcorn container is correctly placed
on the base unit. The popcorn outlet must be located on
the sloping end of the bottom of the popcorn container.
4. Pour the contents of the lid/measuring cup (approx. 60 g)
into the opening in the upper housing and place the lid on
it.
5. Place a bowl under the popcorn outlet.
6. Connect the device to a properly installed and easily ac-
cessible plug socket.
7. Switch on the device by moving the On/Off switch to po-
sition I.
25.05.2016 16:40:24
25.05.2016 16:40:24