Maintenance; Lubrication - Triton TRP UL Instructions D'utilisation Et Consignes De Sécurité

Maintenance

WARNING: Always ensure that the tool is switched off and the plug is removed
from the power point before making any adjustments or maintenance
procedures.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose
over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Triton service centre. This
advice also applies to extension cords used with this tool
Drive belt replacement
It is suggested that you wear leather gloves to change the belt in case you
make contact with the blades
1. To replace the drive belt first take out the five crosshead screws that
secure the drive belt cover on the left-hand side of the planer as viewed
from the rear 2. Remove the damaged belt and use a soft brush to clean
the pulleys and the surrounding area
Note: Wear eye protection when cleaning out the pulley area.
3. With the four continuous 'V' profiles on the inside, place the new belt over
the bottom pulley
Half fit the other end of the belt on the top pulley then roll the belt in place
whilst turning the pulley
4. Check that the belt runs evenly by manually turning the belt
5. Replace the cover and the five fixing screws
6. Connect the tool to the power supply and run the planer for a minute or two
to make sure that the motor and belt are operating correctly
GB
10
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and
gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to
wear quickly, and shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not
sufficient, a mild detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation
holes (where applicable)

Lubrication

• Lubricate all moving parts with a suitable lubricant spray, at regular
intervals
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are
no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools