switel DCT417 Série Mode D'emploi page 109

OGM SETTINGS
ANSWER DELAY
2 RINGS
TIME SAVER:
RECORD TIME
REMOTE ACC.
COMPRESSION
SCREENING
CHANGE PIN
Taking a call from the answering machine
You can take a call on the handset and talk directly to the caller even if the
caller has already started to record a message on the answering machine.
C
Remote access/Remote control
Remote access/remote control can be started from any DTMF−capable
phone. Dial your own telephone number from the external phone. If the
answering machine is switched off, it answers after 10 rings. If it is
switched on, it answers after the preset answer delay. Press the Star button
while the outgoing message is playing and enter the remote access PIN.
Record/Play your outgoing message.
Use the arrow buttons to select a delay period (number
of rings) before the answering machine takes a call:
(2, 4, 6, 8 rings): Take the call after 2, 4, 6 or 8 rings.
If new messages have been recorded, the answering
machine takes a call after two rings.
If no new messages have been recorded, the call is
taken after six rings. Therefore, when using the remote
access feature, you can check if new messages have
been recorded or end the call before a connection is
established if no messages have been recorded.
Use the arrow buttons to define the time available for
recording a message (60S, 120S, 180S, UNLIMITED).
Switch the remote access feature ON or OFF.
Use the arrow buttons to select the compression of the
voice recordings (LOW, MEDIUM, HIGH). This setting
affects the recording capacity and quality. When LOW is
set, the quality is very good but the recording time is at
its shortest. Select HIGH compression for the highest
possible recording time.
Switch the screening of incoming messages via the
base station loudspeaker ON or OFF. This feature
allows you to listen to the caller whilst they are
recording their message. Then if you want to intercept
the call lift the handset and press the Off Hook button. If
you do not wish to be disturbed by calls then set this
feature to OFF.
Enter the remote access PIN (default status 0 0 0 0).
This PIN is required if remote access/control is made
from an external DTMF−capable phone.
Press the Off−hook button.
109