Safety; Before Using The Appliance - ETNA A814VRVS Manuel D'utilisation

Before using the appliance

The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
Only use the appliance if it has been built in
correctly. Damage to an incorrectly installed
appliance is excluded from the guarantee.
During repair and cleaning the appliance needs
to be disconnected from the power supply
(electricity and gas). Remove the plug from
the wall socket or turn the switch in the metre
cupboard to zero (for gas hobs with a spark
switch). Turn off the gas tap in the feeder pipe.
This cooking appliance is designed for
household use. It should only be used for
preparing meals.
When boiling and frying the hob gets hot.
Please pay close attention to small children.
Grease and oil are flammable when over-
heated. Stay near the appliance when
preparing dishes.
Do not use the appliance to heat the kitchen.
This will produce a damp atmosphere.
When a gas cooking appliance is being used
heat and moisture is produced in the area
where the appliance is situated. Make sure
that the area is sufficiently ventilated; open
natural ventilation openings or fit a mechanical
ventilator (extractor). When the hob is used for
longer periods extra ventilation may be needed,
such as an open window or a higher setting on
the ventilator (extractor).
The burners should not be used without pans.
Never place aluminium or plastic trays directly
onto a burner.
Be careful with the cables of electrical
equipment, such as a mixer. These should not be
allowed to touch hot burners.
The underside of the built-in hob becomes hot.
Take care that you do not place any flammable
or plastic objects in any drawer under the
appliance.
Never flambé under an extractor hood.
The high flames can cause a fire, even if the
fan is switched off.