Installation; Assembly; Assembly Of Built-In Gas Hob - ETNA A814VRVS Manuel D'utilisation

Installation

General
The fitting of the appliance should only be carried
out by a registered Corgi gas fitter.
Please note:
The type of gas and the country for which the
appliance has been designed are indicated on the
ratings plate.
This is a category 3 appliance.
Gasconnection EN10226 standards
The gas connection must comply with national
and local regulations.
We recommend that the hob be connected
by means of a fixed pipe. Connection using
a specially designed safety hose is also
permitted.
Behind an oven use must be made of a pipe made
entirely out of metal.
Please note:
A safety hose may not be bent and must not come
into contact with moving parts of kitchen units.
In all cases the connection tap for the appliance
must be positioned such that it is easily
accessible.
Before using the appliance for the first time check
the connections using water and washing-up
liquid to ensure that there are no gas leaks.
Please note:
The bottom of the hob becomes hot.
Electrical connection
230 V - 50 Hz – 1,1 VA
The electrical connection must comply with
national and local regulations. Wall socket and
plug must be accessible at all times. If you want
to make a fixed connection, ensure that a multi-
pole switch with a distance between contacts of
3 mm is installed in the supply cable.
Please note:
This appliance must be earthed. If the connecting
cable is damaged, it may only be replaced by
the manufacturer, the manufacturer's service
organisation or equivalently qualified persons, in
order to avoid dangerous situations.

Assembly of built-in gas hob

Please note:
Do not install a hob next to a high cupboard or
wall made of flammable material. (If there is
no alternative, ensure that there is a minimal
distance of 40 mm between the outer edge of the
hob and the wall in question. Also ensure that
there is a minimum distance of 65 cm between the
hob and any overhead extractor fan which may be
installed).