Tool Holder, Attachments - Festool CXS Notice D'utilisation D'origine

– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
Charger MXC suitable
– for charging the listed battery packs.
– only for indoor use.
The user is liable for improper or non-in-
tended use; this also includes continuous in-
dustrial operation.
6 Operation
6.1 Changing the battery pack [2]
 Battery pack is ready for use immediately upon
delivery and can be charged at any time.
 Side of the belt clip [2-1] can be replaced when
battery pack is removed.
6.2 Charging the battery pack [3]
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - continuous light
Charger is ready to use.
LED green - light flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - light flashes slowly
Battery pack is charged to 80% and
with reduced current.
LED green - continuous light
Battery pack is charged.
LED red - light flashes
General fault indicator, e.g. incom-
plete contact, short circuit, defec-
tive battery pack, etc.
LED red - continuous light
Battery temperature is outside per-
missible limit values (0 °C to 45 °C).
7 Settings
WARNING
Risk of injury

Always switch off the machine before adjusting
settings!
7.1 Changing direction of rotation [1-5]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-4]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Adjusting torque [1-1]
The arrow [1-3] aligns with the adjusted state.
Drilling
Drilling symbol [1-2] on adjustment ring aligns
with the arrow = maximum torque..
Fastening
Torque corresponding to setting:
Position 1 = low torque
Position 12 = high torque
8

Tool holder, attachments

WARNING
Risk of injury, electric shock

Always disconnect the battery pack before any
type of work on the machine!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2 Chuck BF-FX8 [5]
For clamping drill bits and bits with max. shaft di-
ameter of 8 mm.
Clamp tool centricly in the chuck.
8.3 Elbow adapter XS-AS [6]
(accessories) Drilling and screwdriving at right an-
gle to machine.
 You can engage the elbow adapter in 16 different
angle settings.
8.4 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
9 Working with the machine
9.1 On/Off switch [1-6]
Press = ON, release = OFF
 The speed of the machine depends on how far
the on/off switch is pressed in.
CXS
GB
13