Tool Holder, Attachments - Festool QUADRILL DR 18/4 E Notice D'utilisation D'origine

a hazard, have them replaced by an authorised
after-sales service workshop.
– Always guide the cable backwards away from the
machine.
– Take care when drilling into walls as there is a
danger of rupturing concealed gas/water pipes
or cutting through power cables.
– Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated re-
sidual current of 30 mA or less.
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.
WARNING
Risk of injury, electric shock

Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
6.1 Switch on/off
On/off switch [1-7]
Press = ON, release = OFF
 The speed of the machine depends on how far
the on/off switch is pressed in.
Speed set button[1-4]
Press once = ON, press twice or press on/off switch
= OFF
6.2 Attaching the additional handle[2]
Always use the additional handle.

Position the additional handle [2-2] on the ex-
tension of the gearbox housing and engage the
recesses on the additional handle in the lugs on
the housing.

Turn the handle until secured in position.
 Turn the handle to adjust the position in 30° in-
crements.
 The drilling depth can be adjusted using the
depth stop [2-1].
7 Settings
7.1 Changing the rotational direction[1-8]
• Switch to the left = clockwise
• Switch to the right = anticlockwise
7.2 Changing gear[1-6]
Only press the speed switch when the ma-
chine is off. Otherwise there is a danger of
damaging the gearbox.
7.3 Selecting the operating mode (only PD
20/4 E)
Fastening / Drilling
Set the selector switch [1-5] to the drill bit
symbol.
When fastening, always remember to work
in 1st gear and at low speeds.
Impact drilling
Set the selector switch [1-5] to the hammer
symbol.
 The machine was designed for impact drilling
into tiles, masonry and stone.
8

Tool holder, attachments

WARNING
Risk of injury, electric shock

Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
8.1 CENTROTEC tool chuck [3]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2 Chuck [4]
The drill chuck retains the drill or screwdriver bit.
CAUTION
Risk of injury

Clamp the tool centrally in the drill chuck!
 Before initial use: apply a coat of multi-purpose
grease to the drill spindle.
Q U A D R I L L
GB
13