Tool Holder, Attachments; Working With The Machine - Festool DRC 18/4 Li Notice D'utilisation D'origine

DRC 18/4 Li
GB
7.2 Changing gear
You can change gear using the gear switch [1-6].
7.3 Adjusting the torque[1-7]
Fastening
Select the correct torque setting:
Position 1 = low torque
Position 12 = high torque
An acoustic signal sounds when the preset torque
is reached and the machine then switches off. You
must release and press the ON/OFF switch [1-4]
again to start the machine.
Drilling
Mark is aligned with drill symbol
torque.
8

Tool holder, attachments

WARNING
Risk of injury
Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-
tive.
Wear protective gloves.
Prior to initial use: apply multi-purpose grease
to the drill spindle and gearbox neck.
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2 Chuck [5]
For clamping drill bits and bits with max. shaft di-
ameter of 13 mm.
Clamp tool centrally in the chuck.
8.3 Angle attachment [6]
Drilling and screwdriving at right angle to machine
(partly as an accessory).
12
8.4
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
8.5
The depth stop (partly as an accessory) allows the
user to insert screws to a predefined depth. You can
set the dimension by which the screw head pro-
trudes above or is recessed below the surface of the
workpiece.
Depth setting
= maximum
Sleeve A/B must be removed before a screw can be
unscrewed.
9
Risk of injury
Always secure the workpiece in such a manner
that it cannot move while being machined.
9.1
Press = ON, release = OFF
The speed of the machine depends on how far
the on/off switch is pressed in.
9.2
Magnetic, for storing bits and bit holders.
9.3
The belt clip (right/left) allows the user to attach
the machine briefly to work clothing.
9.4
Position the additional handle [3-2] on the ex-
tension of the gearbox housing and engage the
recesses on the additional handle in the lugs on
the housing.
Turn the handle until secured in position.
Turn the handle to adjust the position in 30° in-
crements.
The drilling depth can be adjusted using the
depth stop [3-1].
9.5
Acoustic warning signals sound and the machine
switches off in the following operating states:
Tool holder in the drill spindle [7]
Depth stop [8]
Turn the housing [8-1] to set the
desired fastening depth. Each
detent position changes the fas-
tening depth by 0.1 mm.

Working with the machine

WARNING
On/Off switch [1-4]
Bit store [1-3]
Belt clip [1-9]
Attaching the additional handle[3]
Always use the additional handle.
Acoustic warning signal