Trigger Output - SKF TKRS 21 Mode D'emploi

Start
By pressing button 1 "start" the leading edge of the trigger signal is used to
start stroboscope flash. The blue rectangle on the screen indicates that the
leading edge of the signal is used.
End
By pressing button 2 "end" the tailing edge of the trigger signal is used to
start the stroboscope flash. The blue rectangle on the screen indicates that
the tailing edge of the trigger signal is used.
Divider / Multiplier
There is no multiplier in TKRS 31.
When a sensor is used on a geared wheel, or an encoder is used to trigger
the strobe, the number of teeth or impulses has to be set as divider to get
one flash per rotation.

4.3.4 Trigger output

The trigger output allows the stroboscope to send a signal of the current
flash via the trigger port.
After connecting the trigger, press button 2 "output" in the trigger pop-up to
activate the trigger output. The trigger output symbol appears in the top bar
to indicate that the stroboscope is sending an output signal.
OUT
Fig. 12 – Trigger output
The trigger output can be stopped by removing the trigger cable.
18 EN