Brita PURITY Quell ST Mode D'emploi page 35

Total volume meter
Briefly press button 2 x (< 1 second), the following message appears.
•
00 level current data (today)
The total volume meter is managed at this level; it counts up from 0 irrespective of the cartridge
change.
Memory Call-Up
In the Memory Call-Up mode, the data of the last 4 filter cartridges used can be called up.
Briefly press button 3 x (<1 second) until the following message appears.
•
-1, -2, -3, -4 level – data of the cartridges used before the current one.
Carbonate hardness
Total meter reading when
changing the filter cartridge
At the top left, the indicator for the filter cartridge (-1 for previous filter cartridge) is displayed alter-
nately with the carbonate hardness set and the hardness unit. At the top right, the filter system
size is displayed alternately with the by-pass setting (display 1 s indicator, 1 s carbonate hardness),
at the bottom left, the meter reading when changing the cartridge (-1) and at the bottom right,
the installation date of the cartridge.
Meaning: the filter cartridge most recently used was a PURITY 1200 cartridge, the filter cartridge
was inserted on 25/06/09 and operated up to a meter reading of 23166 litres.
The carbonate hardness set was 14°KH and the by-pass measured was 30%.
The same applies to the cartridge(-2), preceding filter cartridge and the other preceding filter
cartridges -3, -4.
Error Messages
Error level E1 indicates whether an error has occurred in blend detection.
E1 is activated as soon as the current bypass is not correctly identified.
The word Start is then displayed together with the date of occurrence.
As soon as the current bypass setting is identified correctly again, the error has ended and the Stop
date is added. At error level 01 the Stop and Start display alternates every second.
00 Indicator for current level
Total volume meter
By-pass
alternating
alternating
Filter system size
Current date
Cartridge indicator
Date of inserting the cartridge
Type
EN
33