Brita PURITY Quell ST Mode D'emploi page 29

Press and hold the button (> 2 seconds) until the
•
desired unit of hardness has been selected.
Press the button once (< 1 second) to access the next
•
parameter input hardness value. The hardness value
input flashes.
Press and hold the button (> 2 seconds) until the value
•
for the water hardness rises and keep it pressed until
the desired value has been reached.
Press the button (< 1 second) to access the next
•
parameter input monthly limit. The monthly limit input
flashes.
Press the button (> 2 seconds) and keep it pressed
•
until the desired value has been reached.
The set parameters can now be accepted.
If you want to accept the parameters, proceed as follows:
Press the button once (< 1 second) until the message
•
"Reset" appears and flashes.
Press the button once (> 2 seconds) until the total
•
capacity (at 0% bypass) and the current date appear.
The set parameters have been accepted.
Note: If no input is made within 30 seconds, the display will return to standby or operating mode
without accepting amended parameters.
Insert the display unit from the front at a height of approx. 10 mm and slide down. The loops on
•
the display part must be inserted in the grooves on the measuring head. Continue with Chapter
5.4 Flushing/Draining for Filter Systems with and without Measuring and Display Unit.
> 2 sec
< 1 sec
> 2 sec
< 1 sec
> 2 sec
< 1 sec
> 2 sec
EN
27