Brita PURITY Quell ST Mode D'emploi page 32

6.1 Removing the Filter Cartridge
Switch off power supply to the terminal device (remove plug).
•
Close inlet valve
•
Place the flushing hose in a bucket and remove pressure from the filter system by opening the
•
flush valve. Catch the escaping water in a bucket.
Note: If the escaping water is more than 1 litre, the inlet valve
blocked with scale.
Place the pressure vessel lid
•
Note: Do not turn the lid horizontally on its head.
Stand on the kick loops
•
the mantle handles
Take your feet off the kick loops
•
the mantle handles
Remove exhausted filter cartridge
•
Place the exhausted filter cartridge
•
remaining water (> 5 min.).
Lock the exhausted filter cartridge
•
cartridge and return in the original packaging to the appropriate BRITA address listed on the
back of the cover.
EN
6.2 Inserting the Filter Cartridge
Switch on power supply to the terminal device (plug).
•
To flush and bleed the new filter cartridge
•
30
at inlet hose .
7 6
Stand on the kick loops
•
lid by pressing the lock
3
vertically on both lid handles
3
with both feet while turning the pressure vessel
12
as far as it will go.
16
and press the pressure vessel
12
.
16
2
2
2
Check the connector seat of the filter cartridge O-ring
•
lid for dirt and damage.
1
Check that the O-ring seal of the filter cartridge
•
groove and also check for dirt and damage.
Note: The cartridge seat has been lubricated with food-safe lubricant at the
factory.
Place the new filter cartridge
•
Stand on the kick loops
•
clockwise until the mantle handle
Stand on the kick loops
•
lid on the pressure vessel
3
lid handle must line up with the "INSERT" groove.
20
Press the pressure vessel lid
•
engages.
with both feet while opening the pressure vessel
12
and turning it anticlockwise as far as it will go.
15
from the pressure vessel
in the sink with the connection facing down to drain the
with the transport protective cap
in the pressure vessel
2
with both feet, lift the pressure vessel
12
is over the kick loops
16
with both feet and place the pressure vessel
12
. The positioning of the arrow marking on the
1
down and turn clockwise until the lock
3
carry out the steps described under 5.3.
2
is not completely closed or is
7
.
20
anticlockwise by
1
down with both hands on
1
.
1
of the new filter
18
in the pressure vessel
2
is correctly seated in the
2
.
1
1
.
12
turning it
15