Flotec FPCP Série Notice D'utilisation page 3

Installation
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks, mas-
ter switches, and by removing starter keys.
Risk of electric shock. If your basement
has water or moisture on floor, do not walk on wet area
until all power has been turned off. If shut-off box is in
basement, call electric company to shut-off service to
house, or call your local fire department for instructions.
Failure to follow this warning can result in fatal electrical
shock.
When pump is plugged in, do not handle pump, cord, or
plug with wet hands or when standing on a wet or damp
surface or in water. Unplug pump before servicing it or
doing any maintenance on it.
Fire and explosion hazard. Do not use this
pump to pump flammable or explosive liquids. Use pump
only with liquids compatible with pump component mate-
rials. Do not use pump in explosive atmospheres.
Risk of flooding. If for any reason property
damage or personal injury can result from an inoperative
or leaking pump, an auxiliary switch backup system
and/or an alarm should be installed with pump.
INSTALLATION
Pump must be level!
Pump can also be installed
on wall or floor. Allow at least
6-1/2" vertical clearance to
allow tank removal.
Mount pump on side of furnace (or on floor or
1
wall).
Electrical shock and carbon monoxide haz-
ards. When mounting the pump on the side of the fur-
nace, make sure that the mounting holes clear the heat
exchanger and all wiring. The mounting screw for the
pump should touch only the pump reservoir flange and
the exterior sheet metal on the furnace. If in doubt or if
this is confusing, consult a qualified HVAC serviceman or
the furnace manufacturer.
For parts or assistance, call Flotec Customer Service at
From A.C.
Unit
Gas
Condensing
Furnace
Mount Pump
below all Heater
and A.C. Drains
5490 0906
A t
l e
a s
t 6
- 1
/ 2
"
AC Unit
Condensate
Furnace
Drain
Condensate
Drain
Plastic
Tubing
Run plastic tubing as shown into pump's drain inlet
2
hole(s).
Make sure that the tubing to the pump intake is fastened
securely so that it cannot come out of the pump intake
port. Check for local code requirements. You must comply
with codes.
3/8" ID Tubing
To Floor Drain
or Laundry Tub.
Do not kink tube!
1/2" Hose
Clamp
Run tubing as shown from hose barb on pump
3
discharge to floor drain or laundry tub.
1-800-365-6832
3
Cut tubing at an angle
so that bottom of
reservoir doesn't close it.
Be sure tubing does not
interfere with float.
1-1 1 2 " above
bottom of
reservoir
5491 0906
Ceiling and Joists
Discharge tube should
slope down toward
outlet if possible
5492 0906