Dialling Mode - Abus Terxon PSTN Instructions D'installation

IMPORTANT
When no telephone number is programmed, the display shows
"BLANK". Press the
number.
Enter the desired telephone number.
IMPORTANT
Press for a dial pause of three seconds. This is shown in the
display as a comma. The entry cursor can be moved to the left by
pressing or to the right by pressing
Press the
Repeat this procedure for numbers 2, 3 and 4.
Press to end data entry.

10.1.2 Dialling mode

This function is used to switch the dialling mode from DTMF (tone
dialling) to pulse dialling. You can also select automatic recognition of
the correct dialling mode (AUTOMATIC setting).
1. Enter your programming code (default: 1234). The following
message is shown in the display:
Press . The display shows the following:
Press -
changes between the selected telephone number and the programmed
number.
key to delete the programmed telephone
key to save the entries.
to enter telephone numbers 1-4. The display now
123456
.
READY
ENT 1-4
TEL NO 1
49