Storage (Over 30 Days); How To Order Replacement Parts - BEAL NPMS12 .5/96 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

How To Replace The Mower Drive Belt (Figure 10)
1.
Remove the mower housing. See the instruc tions on
"How To Remove The Mower Hous ing".
2.
Remove the pulley guard.
3.
Pull the
belt retainer (A) away from the idler pulley (B)
and remove the mower drive belt (C).
4.
Pull the
belt retainer (D) away from the right mandrel
pulley (E) and remove the mower drive belt (C).
5.
Pull the
belt retainer (D) away from the left mandrel
pulley (F) and remove the mower drive belt (C). A
correct replacement part or assistance is available from
an Authorized Service Centre in your area.
6.
To install the mower drive belt, reverse the above steps.
How To Remove The Mower Housing (Figure 22)
1.
Move the
blade rotation control (A) to the DISENGAGE
position.
2.
Move the
lift lever (B) to the level adjust ment position.
CAUTION: The lift lever is spring loaded. Make sure the lift
lever is locked in the LEVEL ADJUSTMENT position.
3.
Remove the hair pins and the washers from the
adjuster arms (C). See illustrations "3" and "4".
4.
Remove the hair pins and washers from the
links (D). See illustrations "1" and "2".
5.
Disconnect the
extension spring (E) from the blade
control rod (F). See illustration "5".
6.
Disconnect the
front hanger (I) from the axle support.
See illustration "6".
7.
Remove the
mower drive belt (G) from the stack
pulley (H).
8.
Pull the mower housing away from the right side of the
unit.
9.
To install the mower housing, reverse the above steps.
How To Replace The Fuse
If the fuse is blown, the engine will not start. Remove the
fuse and replace with a 15 amp. automotive fuse.
22

Storage (over 30 days)

At the end of each year, prepare the unit for stor age as
follows.
1.
Drain the fuel from the carburettor and the fuel tank.
Change the engine oil. See the en gine manufacturer's
instructions.
2.
Clean the entyre unit.
3.
Charge the battery.

How to Order Replacement Parts

The replacement parts are shown either on the back pages of
this Instruction Book or in a sep arate Parts List Book.
Use only manufacturer's authorized or approved replacement
parts. Do not use attachments or accessories not specifically
recommended for this unit. In order to obtain proper
replacement parts you must supply the model number of
your mower (see nameplate).
Replacement parts, except for the engine, trans mission,
transaxle or differential, are available from the store where
the mower was purchased or a service shop recommended
by the store.
Warranty service is available only through Autho rized Service
suspension
Dealers.
Replacement parts for the engine, transaxle, or transmission,
are available from the manufac turer's authorized service
centre found in the commercial pages of the telephone
directory. Also, see the individual engine or transmission
warranties to order replacement parts.
When ordering the following information is re quired:
1.
The Model Number
2.
Serial Number
3.
Part Number
4.
Quantity
www.yvanbeal.fr

Publicité

Chapitres

Table des Matières
loading

Table des Matières