Connecting The Digital Audio Out Terminal; Connecting The Lan (10/100) Port; Connecting To An Ethernet Hub - Pioneer HD-V9000 Mode D'emploi

Note
• Only video signals with NTSC or PAL resolutions are
output from the VIDEO OUT terminal. Set the output
using the TV SYSTEM (NTSC, PAL) switch on this
unit's rear panel (page 26).
• Video signals with the resolution set at Setup are
output from the COMPONENT VIDEO OUT terminals
(set to 480/59.94i (USA and Canadian models)/576/50i
(European model) upon shipment from factory). It is
not possible to output signals with a resolution
differing from the HDMI output (page 46).
• When EDID is set to On and HDMI connections are
used, the HDMI output's resolution setting has
priority, so the output resolution of the signals output
from the COMPONENT VIDEO OUT terminals may
change automatically (page 46).
• When there is a display for monitoring, we
recommend connecting it to the VIDEO OUT
terminal.
Connecting the DIGITAL
AUDIO OUT terminal
Rear panel
L
DIGITA L
AU DIO
RS-232C AU DIO OUT
OUT
R
2-channel
analog audio
signals can
also be
connected.
To audio input
terminals
Note
• The following linear PCM signals can be output from
this unit's DIGITAL AUDIO OUT terminal:
– Sampling frequency: 48 kHz
– No. channels: 2
• To switch the picture with the amplifier, also connect
the VIDEO OUT terminal.
HDMI
COMPONENT
OUT
VIDEO OUT
VIDEO OUT
Y C B / P B C R / P R
NTSC ON
TV
75
SYSTEM
P AL OFF
EXT S
Direction of
signal flow
To coaxial digital
audio input terminal
Amplifier
Connecting the LAN
(10/100) port
Use this to connect this unit to a hub connected to a
network, etc. For details on this unit's network functions,
see page 70.
Be sure to connect to an Ethernet hub or router
compatible with 100BASE-TX.
Connecting to an Ethernet
hub
This unit can be connected to an Ethernet hub using a
LAN cable.
Caution
• Use an STP cable for the LAN cable. Failure to do so
could result in serious electromagnetic problems.
Rear panel
VIDEO OUT
NTSC ON
TV
75
SYSTEM
P AL OFF
EXT SYNC IN
LAN
3
Ethernet hub
(router with hub
functionality)
Note
• The LAN indicator on front panel lights when
connected to the network (page 25).
• If DHCP is set to TYPE in the network settings and
there is an available DHCP server on the connected
network, the IP address is obtained automatically. If
no DHCP server is available, set the IP address
manually (page 49).
• Note that Pioneer will accept no responsibility
whatsoever for any communication errors or
malfunctions associated with your network
connection and/or your connected equipment.
Please contact your network device manufacturer.
LAN(10/100)
LAN cable
(commercially
available)
2 1 WAN
03
33
En