Network Settings; Play Menu - Pioneer HD-V9000 Mode D'emploi

Network Settings

The network settings are made here. If settings are changed, be sure to either close the Setup screen or return to the
top Setup screen, then turn off the power. The settings are reflected when the power is turned back on (aside from the
Wake Up On LAN setting). For details on this unit's network function, see page 70.
Setting item Settings
Disable
Network Connection
Enable
Auto IP
Type DHCP
Manual
IP Address
Input this unit's IP address.
Subnet Mask
Input the subnet mask.
Default Gateway
Input the default gateway.
Primary DNS
Input the primary DNS server's IP address.
Secondary DNS
Input the secondary DNS server's IP address.
Off
Wake Up On LAN
On
MAC Address Displays the MAC address.
FTP Username
Input the FTP username.
FTP Password
Register the FTP password.
FTP Port
Input the FTP port.
Remote Port
Sets the remote port.
Proxy Address
To use the proxy server when connecting to the Internet to use the RSS function, set the address.
Proxy Port
Set the proxy server's port number.
Disable
NTP
Enable
NTP Server Address
Set the NTP server's IP address or URL.
GMT ± **:**
Time Zone
(GMT ± 00:00)
1. For instructions on inputting numbers, see page 38.
2. For instructions on inputting characters, see page 39.
3. The unit's clock is set automatically at the following times:
– When the unit's power is turned on
– At intervals of 1 hour after the unit's power is turned on
– When the NTP-related settings are changed
Caution
• Prior permission from the distributor is required in order to access NTP servers on the Internet.

Play Menu

For details, see page 39.
Description
Select this when not using the LAN function.
Select this when using the LAN function.
The IP address is set automatically.
The network settings are acquired from the DHCP server.
Set the IP address manually.
1
1
1
1
1
The Wake Up On LAN function is disabled (page 70).
The Wake Up On LAN function is enabled (even if Network Connection is set to
Disable).
2
(Default value: HDVIDEO)
1
(Default value: PASS)
1
(Default value: 00021)
1
(Default value: 10001)
1
(Default value: 01234)
This unit's clock is set to the time set at Clock Setting (page 47).
This unit's clock is set automatically by acquiring the time information from the
3
Clock Setting cannot be set (page 47).
NTP server.
2
Set the offset time with respect to the time acquired from the NTP server (GMT).
06
2
49
En