ST EL 340 Li 48L Manuel D'utilisation page 63

The motor does not
1.
start when the switch is
pressed.
The motor is running but
2.
the blade is stationary.
The motor shuts down
3.
whilst working.
The cut grass is
4.
not collected in the
grass catcher.
Mowing is difficult
5.
Excessive noise and/or
6.
vibration is
experienced
whilst working.
Battery power
7.
reserve is low.
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Low battery.
Motor start-up is slow.
The thermal protection has tripped
due to overheating of the motor.
The blade fittings are loose.
Battery is not inserted correctly.
Low battery.
Obstructions that prevent
rotation of the blade.
The thermal protection has tripped
due to overheating of the motor.
Thermal protection has tripped due to
excessive current absorption caused by:
• Excessively high grass cutting.
• Obstructions that prevent
rotation of the blade.
• Too much grass debris accumulated
in the chassis and discharge channel.
•
The blade has collided with a foreign
object and received a knock.
The inside of the chassis is dirty.
The blade is not in good condition
Blade fittings are loose or
the blade is damaged.
Severe working conditions requiring
greater current absorption.
Battery is insufficient for
operating requirements.
Insert the key (Fig. 23)
Open the hatch and check that the battery
is fitted in its housing correctly (Fig. 23)
Check the battery status and
recharge if necessary (Fig. 32).
Press and hold the control lever
for 2-3 seconds (Fig. 25).
Wait for at least 5 minutes, then
restart the machine.
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 7.3).
Open the hatch and check that the battery
is fitted in its housing correctly (Fig. 23).
Check the battery status and
recharge if necessary (Fig. 32).
Remove the safety key, put on your work
gloves and remove any grass remains or
debris from the lower part of the machine
and/or the discharge channel.
Wait for at least 5 minutes, then
restart the machine.
• Set a higher cutting height when the
grass is very tall, then set a lower
height and cut the lawn again .
• Remove the obstructions (par. 7.2.2).
• Clean the machine (par. 7.2.1)
Wait for at least 5 minutes, then
restart the machine.
Immediately turn off the motor
and remove the safety key.
Inspect for damage and contact a Technical
service centre for the replacement of
the blade if necessary (par. 7.3).
Clean the inside of the chassis to
ease the grass discharge towards
the grass catcher (par. 7.2.2).
Contact a Technical service centre for the
sharpening or replacement of the blade.
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 7.3).
Optimise operations (par. 7.1.1).
Use a second battery or extended
battery (par. 13.2).
EN - 8