Eureka ATOM Manuel D'instructions page 28

6. INSTRUCTIONS FOR USE
6.1 INTRODUCTION
This appliance can make very precise doses as it refers to grinding time.
It is furthermore necessary to set up the appliance before operating, by determining first of
all the coffee blend type (more roasted or less) and the degree of grinding. Grinding time is
then set for each dose key by weighting the grinding product.
• After having plugged the appliance in, pull the tab (17) at the bottom of the coffee bean
container (8) to close it (see Fig. 4).
• Remove the cover (7) from the container (8) and fill it with coffee beans.
• Turn the switch (11) to the ON position (the led on the button).
• Push the tab (17) permitting passage of coffee beans.
6.2 FUNCTIONING WITH FILTER HOLDER (Espresso coffee)
Insert the fork (15) into the slot (see Fig. 6) and fasten it in its holder. Preselect the single
or double dose using the buttons (3)
to press the (14) button to start dispensing from the nozzle (13). Dispensing stops once the
preset time has elapsed.
6.3 FUNCTIONING WITH TANK (Filter coffee)
Insert the tank (16) below the dispensing spout (13).
Press the button (4)
dispensing. The dispensing always end by pressing the button (4)
6.4 GRINDING SETTING
Set grinding by means of the adjusting knob (10), by rotating it clockwise to make powder
finer (Espresso coffee) or anticlockwise to increase the size of its grain (Filter coffee) as
shown on the knob (see Fig. 5). Setting is stepless; it is to be gradually performed, by grind-
ing some coffee every two notches maximum.
ATTENTION
If the knob is turned by more than 3 notches with the engine stopped, the machine
can get stuck and / or damaged.
After adjusting the grind with the knob (10), deliver 2-3 doses to make effective the new
grinding.
6.5 FILTER HOLDER FORK HEIGHT ADJUSTMENT (Fig. 7)
• By using a crosshead screwdriver, loosen the fastening screw of the filter holder fork (15).
It is recommended not to unscrew the screw completely.
• Raise or lower the fork in order to adjust it according to filter holder dimensions.
• Once having reached the correct position, tighten the fork fastening screw (15).
• The appliance is equipped with a filter holder retaining device.
The fork (15) is designed to support all types of filter holder (from 2,5 to 5 cm).

Depending on the type of filter available, you can change the height of the fork
(15) by inserting it upside down on its support.
10
or (5)
to pass at the "Espresso & Brew" mode and press it again to start
. Insert the filter holder on the fork (15)
.
EN