Rectifying Minor Faults Yourself; Error Messages - Schulthess Spirit TopLine TWP 6707 Mode D'emploi

Problems
Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualified specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.

Rectifying minor faults yourself

The machine does not start after pressing a
programme button:
u Check whether the mains power is switched on at the
wall and the plug is in.
u Check whether all the fuses are intact or the safety
switch has tripped.
The machine does not start:
u The start button has not been pressed.
u Start time preselect has been set. Only starts at the
preselected start time.
The drying target was not achieved:
u Clean filter
u Increase degree of drying (see page 55).
u Clean moisture sensor (see page 54).
The drying takes too long:
u Clean filter.
u Power failure (note lock times of EW).
The laundry is not dry after the maximum
possible settings:
u Drum is overloaded.
u Laundry not sufficiently spun.
u Insufficient room ventilation (open a window or door).
u The filter is blocked with fluff (clean filter).
Drum lighting does not work:
u Faulty light bulb. For safety reasons, the lamp should
only be replaced by customer services or a specialist.
Dampness in the room increases significantly:
u The room does not have sufficient ventilation.
Ensure adequate ventilation.
Door does not open:
u If no power is available to open the door, you can
open the door manually by pressing next to the door
lock.
Washing is wrapped up:
uUse special programmes «bed clothes» or «towelling».
57

Error messages

If the following error messages are displayed, the pro-
gramme can be restarted by pressing the start button
once the error has been rectified.
«Child lock»
u Hold the start button down and press the fast forward
button.
«PLEASE CLOSE DOOR»
u Push door closed until lock engages.
«COND. WATER FULL»
u Condensate water pump is not running.
Check if the water discharge hose is bent or the water
discharge provided by the customer is clogged.
If the machine displays an F - - error message:
u Interrupt the programme using the fast forward button
and select a new programme.
If error messages appear repeatedly:
u Switch off the power for around 1 minute and switch
it back on again. (Pull out the plug or switch off at the
wall).
l The machine is ready for use again when the programme
control lights flash.
u Select a new programme.
If an error message appears again:
u Make a note of the error message.
u Unplug the machine or switch it off at the wall.
u Notify customer services.