Lcd Brightness / Contrast Settings; Alarm; Standby Function; Optical Interface - Schulthess Spirit TC 5587 Mode D'emploi

LCD Brightness setting (ex factory 150)
Select «Extended basic settings»!
The button can be used to alter the brightness or text
on the display.
LCD Contrast setting (ex factory 26)
Select «Extended basic settings»!
The button can be used to alter the contrast on the
display.
Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The volume can be adjusted in 3 levels.
Off
Volume 1
Volume 2
Volume 3
Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off when no drying programme is running in
energy saving mode. All displays are dark.
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Default language (ex factory GERMAN)
Select «Extended basic settings»!
If another language is temporarily selected via the keys
and , 4 minutes after programme end, in standby
mode or after a long standstill, the setting reverts back to
the default language.
56
Problems
Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualified specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.

Rectifying minor faults yourself

The machine does not start after pressing a
programme button:
Check whether the mains power is switched on at the
wall and the plug is in.
Check whether all the fuses are intact or the safety
switch has tripped.
The machine does not start:
The start button has not been pressed.
Start time preselect has been set. Only starts at the
preselected start time.
The drying target was not achieved.
Clean filter
Increase degree of drying (see page 55).
Clean moisture sensor (see page 54).
The drying takes too long.
Clean filter.
Power failure (note lock times of EW).
The laundry is not dry after the maximum
possible settings:
Drum is overloaded.
Laundry not sufficiently spun.
Insufficient room ventilation (open a window or door).
The filter is blocked with fluff (clean filter).
Drum lighting does not work:
Faulty light bulb. For safety reasons, the lamp should
only be replaced by customer services or a specialist.
Dampness in the room increases significantly:
The room does not have sufficient ventilation.
Ensure adequate ventilation.
Door does not open:
If no power is available to open the door, you can
open the door manually by pressing next to the door
lock.