Cleaning The Moisture Sensor; Emptying The Machine For Frost W Protection Or Transport - Schulthess Spirit TopLine TWP 6707 Mode D'emploi

4.
Brush the filter (B) with the hand or a damp towel, remo-
ving the lint.
Replace the filter and secure the blue lever.
Close the maintenance valve.
Filters C + D / Clean weekly
1.
Open the left valve; unlatch the blue lever and remove
the filter (B).
2.
Remove the rear filter (C).
3.
Open the right valve. Pull out the round filter (D).
4.
Wash the two filters under running water at a max. 60°C.
Dry the filters before reusing.
5.
Check whether the fins of the heat exchangers behind
the filters are covered in lint. If yes, carefully vacuum the
fins with the vacuum cleaner (narrow nozzle).
6.
Replace the filter (D). Make sure that the round plastic
insert locks into place. Close the valve again.
7.
Replace the filter (C) as well. Ensure complete overlay.
8.
Replace the filter (B) and lock the blue lever. Re-close the
left valve as well.
54
Replacing defective filters
Defective filters must immediately be replaced with new
ones. You can order the filters with the following number:
Filter A: Order number
Filter B: Order number
Filter C: Order number
Filter D: Order number

Cleaning the moisture sensor

After longer operation, small deposits (lime, fabric refiner)
can form on the front inner side of the drum on both
sides of the longish moisture sensors.
With moisture controlled programmes, this can result in
the desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.
Emptying the machine for frost protection or transport
If the machine is in a room susceptible to frost or is to be
transported, it must be completely emptied.
1.
Select any drying programme.
2.
Press the start button
ning in the machine will then be pumped into the contai-
ner.
3.
Stop the programme after around 5 minutes using the
fast forward button
container again.
635 167
635 185
635 212
635 291
. Any condensed water remai-
and empty the condensed water