Basic Settings; Drying Level; Crease Protection; Time - Schulthess Spirit TopLine TWP 6707 Mode D'emploi

Basic Settings

The machine has basic settings from the factory. It can
be adapted to the user's individual needs either when first
used or later using the following functions.
The basic settings can only be changed if no dry program-
me is running. To change a basic setting, it is first neces-
sary to hold the programme button(s) pressed and then
press the fast forward button. The corresponding function
is shown on the digital display. The display changes when
the fast forward button
the programme button(s) held down.
Example:
Drying level (ex factory NORMAL)
+
When this function is switched on, the level of dryness
for the moisture controlled programmes (wardrobe and
extra dry) is slightly increased and the laundry will be
slightly drier.
Crease protection (ex factory 30 MIN)
+
When this function is switched on, the crease protection
phase begins at the end of the programme.
Time (the time is not set ex factory)
+
The hours can be set using the
tes using the button.
Language (ex factory GERMAN)
+ ÷
This setting is temporarily valid for the selected programme
and reverts back to the default language a few minutes
after completion of the programme.
See «Advanced basic settings/default language»
is pressed repeatedly with
Function switched off
Function switched on
button and the minu-
55

Extended basic settings

+
u By pressing these three buttons at the same time, the
display shows the extended basic settings.
u Repeatedly pressing the
possible settings.
u Pressing the
changed.
u Pressing the
settings.
Child lock (ex factory OFF)
Select «Extended basic settings»!
The child lock is to prevent accidental starting, changing
or deletion of a programme by small children.
Start a programme with the child lock switched on:
+
Hold the start button down and press the fast forward
button.
Button memory (ex factory OFF)
Select «Extended basic settings»!
With switched on memory button function, the special
programme last used is stored and appears again as first
on the display when next pressing the
Following this, the consecutive programmes can then be
selected through repeatedly pressing the button.
This way, a frequently used special programme can be
called up with only one press of the button.
With switched off function the «Wool Finish» programme
appears as first.
LCD Brightness (ex factory 150)
Select «Extended basic settings»!
The button can be used to alter the brightness or text
on the display.
LCD Contrast (ex factory 26)
Select «Extended basic settings»!
The button can be used to alter the contrast on the
display.
Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The volume can be adjusted in 3 levels.
Off
Volume 1
Volume 2
Volume 3
+
button shows the
button allows the settings to be
button ends the display of the
button.