Maintenance / Care / Cleaning; Cleaning The Machine - Schulthess Spirit TopLine TWP 6707 Mode D'emploi

Maintenance / Care / Cleaning

Cleaning the machine

Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water.
Do not use solvents! These substances can damage parts
of the machine, produce poisonous vapour and carry the
risk of explosion!
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-abra-
sive cleaning product.
Cleaning the filter
Filter A / Clean after every drying process
When fabrics are used, the fibres are rubbed (laundry
fluff), which are released when the fabrics are dried,
collecting in the filter on the inside of the door.
The fluff filter must therefore be cleaned after every use.
1.
Press the door open button.
2.
Pull out filter and open it.
3.
Rub your hand over the filter and remove the fluff. It may
happen that a supposedly proper cleaned filter becomes
impermeable, due to a fine, invisible coat remaining in
the filter meshes. Hold the filter with one flat surface up-
wards and pour a little water on to it. If it is impermeable,
clean the filter with a ibrush under running water.
53
3.1
From time to time it is necessary to remove fluffs that
have accumulated inside the filter support. To do so, use
a vacuum cleaner or a cleaning brush.
3.2
Run the pipe of the vacuum cleaner or the brush around
the opening for the fluff filter. Remove any residual fluff.
4.
Replace the filter properly.
5.
Close the door.
Additional Filter B, below / Clean after every
wash day
1.
Press the button; the maintenance valve springs open.
2.
Rotate the two fastening levers against one another in
the direction of the arrows.
3.
Pull the filter out.