Maintenance, Care, Cleaning; Cleaning The Machine; Cleaning The Filter; Cleaning The Moisture Sensor - Schulthess Spirit TopLine TA 6692 Mode D'emploi

Maintenance / Care / Cleaning

Cleaning the machine

Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water.
Do not use solvents! These substances can damage parts
of the machine, produce poisonous vapour and carry the
risk of explosion!
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-abra-
sive cleaning product.

Cleaning the filter

When fabrics are used, the fibres are rubbed (laundry
fluff), which are released when the fabrics are dried,
collecting in the filter below the door.
The fluff filter must therefore be cleaned after every use.
1.
Press the door open button.
2.
Pull out filter and open it.
3.
Rub your hand over the filter and remove the fluff. It may
happen that a supposedly proper cleaned filter becomes
impermeable, due to a fine, invisible coat remaining in the
filter meshes. Hold the filter with one flat surface upwards
and pour a little water on to it. If it is impermeable, clean
the filter with a brush under running water.
53
3.1
From time to time it is necessary to clean the seal at the
inner edge of the filter support and to remove fluffs that
have accumulated inside the filter support. To do so, use
a vacuum cleaner or a cleaning brush.
3.2
Run the pipe of the vacuum cleaner or the brush around
the opening for the fluff filter. Remove any residual fluff.
4. Replace the filter properly.
5. Close the door.

Cleaning the moisture sensor

After longer operation, small deposits (lime, fabric refiner)
can form on the front inner side of the drum on both
sides of the longish moisture sensors.
With moisture controlled programmes, this can result
in the desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.